Supported platforms: CODESYS 2.3, CODESYS 3.5, CODESYS 3.5 SAFETY
The following table describes the communication settings for different hardware platforms. These settings are needed when configuring communication parameters in CODESYS.
Platform |
Using CAN |
Ethernet |
E Series / S Series |
Use communication dialog, see section Going Online and Downloading Application |
Not supported |
6000/X Series |
Not used for application download |
Type: TCP/IP (Level 2) Address: ETH 1 IP address 192.168.0.2 or disabled (by default) |
5050 (CODESYS 3.5) |
Use communication dialog, see section Going Online and Downloading Application |
Type: TCP/IP (Level 2) Address: IP address 192.168.0.2 (by default) |
5050 (CODESYS 2.3) |
Type: CANopen DSP302 Node-ID: CODESYS communication node-ID needed Node Sent Offset: automatically set by CODESYS from node-ID Node Recv Offset: automatically set by CODESYS from node-ID CAN bus baudrate: Needed CAN card driver: DLL name without file extension for used USB-CAN card. Motorola byte order: Yes |
Type: TCP/IP (Level 2) Address: IP address 192.168.0.2 (by default) Port: 1200 BlockSize: 1400 Motorola byte order: Yes |
4xxx / 3xxx 202x / 203x |
Type: CANopen DSP302 Node-ID: CODESYS communication node-ID needed Node Sent Offset: automatically set by CODESYS from node-ID Node Recv Offset: automatically set by CODESYS from node-ID CAN bus baudrate: Needed CAN card driver: DLL name without file extension for used USB-CAN card. Motorola byte order: No |
Not supported |
2040 Display Unit |
Not used for application download |
Type: TCP/IP (Level 2) Address: IP address xxx.xxx.xxx.xxx Port: 1200 Motorola byte order: No |
EPC-i10 |
Not used for application download |
Type: TCP/IP (Level 2) Address: IP address xxx.xxx.xxx.xxx Port: 1200 BlockSize: 128 Motorola byte order: No |
Source file topic100330.htm
Last updated 13-Jun-2024