Always use an external fuse to protect the control unit. The fuse is needed for reverse voltage and overload protection.
Nominal supply voltage 12/24 VDC
Operating range 8,5…33 VDC
Undervoltage reset ≤ 8 VDC
Max. 70 V (Stresses above this value may cause permanent damage to the module.)
Control unit has a shutdown circuit which protects the unit and loads against overvoltage. The shutdown circuit cuts off the power feed for the logic and loads in case of overvoltage. The shutdown circuit is activated when voltage reaches circa 35 V. Power feed is restored when supply voltage drops to 32,5 V.
Approx. 1,5 W (+24 VDC, no external load)
Supply Voltage (Uin) maximum continuous current 13 A (with full external load)
GND current sum max 13 A
Power supply pins
|
Designation |
Connector / pin number |
Potential |
|
Supply voltage (Uin; for logic and power) |
X4.4 X4.5 |
+12/+24 VDC (+8,5…33 VDC) |
|
Ground (for supply voltage) |
X4.1 X4.3 |
GND |
|
Optional back-up supply * (for CPU) |
X2.11 |
+24 VDC |
|
Ground
|
X1.9 X1.10 X1.11 X2.13 X2.14 X2.15 X3.3 X3.4 X3.11 X3.12 |
GND (3 A/pin) |
|
Supply outputs |
||
|
Auxiliary supply (for external devices) |
X1.13 |
Uin / max 6 A |
|
Reference supply (for external devices) |
X3.1 X3.9 |
+12 VDC / max 200 mA (max total for all pins together) |
|
Reference supply (for external devices) |
X3.2 X3.10 |
+5 VDC / max 270 mA (max total for all pins together) |
* This pin does not provide power supply for current sourcing outputs. Please consult manufacturer before using this pin as a unit voltage supply.
|
|
Always use an external fuse to protect the control unit. The fuse is needed for reverse voltage and overload protection. |
Electrical characteristics
|
Symbol |
Parameter |
Conditions |
Min |
Max |
Units |
|
VI |
Nominal Input voltage |
|
8,5 |
33 |
V |
|
ITOT-max |
Max Total Current Output |
|
|
13 |
A |
|
VI-Load-dump |
Max Input transient Voltage level |
(Note 1) |
|
100 |
V |
|
VI-max |
Max Continuous Input Voltage Level |
(Note 2) |
-0,5 |
40 |
V |
|
VI-ovp |
Overvoltage Protection Cut-off Level |
|
33 |
36,5 |
V |
|
|
Overvoltage Cut-off Hysteresis |
|
typ. 2 |
V |
|
|
VUVP |
Undervoltage Threshold Level |
|
typ. 7,7 |
V |
|
|
Supply voltage monitoring |
|||||
|
VI-range |
Nominal Input Voltage measuring range |
|
0 |
46 |
V |
Note 1: Load dump protection according to ISO7636-2: 2004 pulse 5, Us=+70V
Note 2: If the voltage is less than 8,5 V or higher than 33 V, the control unit is in non-operational state.