|
Control unit mounting location should be planned so that the machine's washing does not damage the unit.
A direct water jet towards the control units should be avoided, especially when using high pressure. Also, the use of any such solvent that causes damage to electronic devices should be avoided when handling the control units.
|
|
When cleaning the control unit, do not use highly alkaline / acidic substances, too hot water, or too heavy mechanical abrasion. |
|
In moist conditions, the unit must be mounted and oriented so that the connectors are not filled with water.
|
|
If the product's assembly screws or product labels have been removed or damaged or the unit housing has been opened in any way, the warranty becomes null and void. |
The mounting is done with 3 pieces of M5 screws
It is possible to use a spring washer under the screw head
Mounting must be done on to a conductive metal base. The control unit's zinc housing must have a galvanic connection to the machine frame
The paint must be removed from the control unit under each screw head before mounting, to ensure a galvanic connection to the control unit frame. Also, remove the paint from the machine frame, where the control unit will be attached.
3-point mounting allows mounting on a slightly uneven surface
Reserve 10 cm installation space for the connector cables
Mounting position must be horizontal or vertical to allow water, etc. flowing away from connectors, see the figures below.
Do not mount the unit in a position where the bottom side or the connectors are facing up.
Do not mount the unit in a position where the connector side is facing up.
