This section describes how to view the device information. The information shown depends on the ApplicationLoader version. The same device information can also be read from /tmp/moduleinfo.txt
Main Unit Information:
Product code
Hardware revision
Serial number
Firmware version
Boot version
Kernel version
CODESYS runtime version
ApplicationLoader version
Number of Ethernets
Ethernet 1 MAC address
Ethernet 2 MAC address
WLAN MAC address
Licenses
Memory Information:
RAM memory size
NVRAM memory size
Flash memory size
Display Information:
Display resolution
Display size
6107 display unit: Boot-up the display unit and press the lower right corner of the display during boot-up until the embedded ApplicationLoader software starts.
6112 and 6807 display unit: Boot-up the display unit and rub the lower right corner of the display during boot-up until the embedded ApplicationLoader software starts.
Navigate to Version Info view:
Return to ApplicationLoader main view by tapping 
in the lower left corner.
Use 6000SystemParameters.library for checking the device information.
At the command prompt, type the following command and press ENTER:
cat /tmp/moduleinfo.txt
Source file topic100337.htm
Last updated 19-Dec-2024