This section describes the PLC-Browser commands implemented in 3606, 3610, 3720, 3724 and 4602 control unit.
PLC-Browser is a text-based control monitor in CODESYS. The given commands are sent as a string to the control unit. The control unit returns a string which is displayed in the PLC-Browser window.
This functionality can be used for diagnostic and debugging.
The available commands and their descriptions are listed in the following table:
Commands with black font are standard commands (3S)
Commands with blue font are Epec specific
Command |
Description |
? |
Show implemented commands |
commparamsset |
Set communication parameters |
comp |
Memorycompare |
compd |
Memorycompare with dump |
cycle |
Get PLC cycle time |
flasprg |
Install application from RAM to flash |
fmem |
Dump FRAM memory |
getcommparams |
Show communication parameters |
geterrorlog |
Get FW error log |
GetNodeId |
Get CANopen node-ID |
getstatistic |
Get flash statistic data |
killapp |
Remove PLC application |
mem |
Memorydump |
memc |
Memorydump relative to code-startaddress |
memd |
Memorydump relative to data-startaddress |
memf |
FRAM memorydump start address[,end address] |
memset |
Memory SET Start, Fill-Byte, Length |
metrics |
Get the PLC metrics |
reflect |
Reflect current command (test!) |
resetcommpars |
Reset communication parameters |
resetprg |
Reset PLC code |
resetprgcold |
Reset PLC code, reboots the control unit |
resetprgorg |
Return factory settings: remove application from unit and delete parameters |
serviceinfo |
Information of control unit |
SetNodeId |
Set CANopen node-ID |
start |
Start application |
stop |
Stop application |
usertest1 |
Test of user command 1 |
version |
Get FW version |
Source file Topic000646.htm
Last updated 21-Feb-2025