What's new?

Highlights in MultiTool Creator 7.8

Support for Epec 6510 Display Unit

Epec has officially released a new 10.1” HMI Epec 6510 Display Unit. 6510 is a powerful embedded display with a great visual performance and large set of features for example four CAN buses and ethernet connectivity. 6510 Display Unit can be programmed either with CODESYS Visualization or C/Qt.

Click here for more information about Epec 6510 Display Unit

Various smaller changes

Improvement: Enable SDO query setting enabled by default for Epec Responders

Improvement: Possibility to check responder configuration by reading it back to the commander

Bugfix: Fixed NMT state machine to use filtered HB state instead of unfiltered

Bugfix: PDO extended COBID and RTR selections did not affect the exported DCF file

Bugfix: Empty PDO mapping caused an exception in MTC when exporting a DCF file

Bugfix: Exporting and importing the DCF file was disabled in Epec Responders when the project was reopened

Bugfix: SRDO COB-IDs were not validated after cloning the unit

Bugfix: Changing unit type from SL84 to SC52 did not work

Bugfix: Parameter value was missing when exporting dcf of a dummy unit

Bugfix: Could not add an Epec Responder to the project if MTC was started from the installer

Bugfix: Heartbeat consumer index 0x1016 was not initialized in code template

Bugfix: Adjusting heartbeat consumer time through OD had no effect

Bugfix: Incorrect pin configurations for MTS in a specific case

Bugfix: Eds export crashed MTC in a specific case

Bugfix: Special characters in J1939 PGNs prevented code template from compiling